TYPE length_or_plane_angle_measure_with_unit_select

(* SCHEMA step_merged_ap_schema; *)

-- IN AP238 STEP-NC/AP242
TYPE length_or_plane_angle_measure_with_unit_select = SELECT
      (length_measure_with_unit,
       plane_angle_measure_with_unit);
END_TYPE;

Referenced By

Defintion length_or_plane_angle_measure_with_unit_select is references by the following definitions:
DefinitionType
 geometric_tolerance_with_defined_area_unit ENTITY
 geometric_tolerance_with_defined_unit ENTITY


[Top Level Definitions] [Exit]

Generated by STEP Tools® EXPRESS to HTML Converter
2025-09-04T17:14:52-04:00