Application module: Model based 3D geometrical dimensioning and tolerancing representation ISO/TS 10303-1816:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM rule definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure D.2 — MIM entity level EXPRESS-G diagram 1 of 1 ../model_based_3d_geometrical_dimensioning_and_tolerancing_representation/sys/5_mim.htm#model_based_3d_geometrical_dimensioning_and_tolerancing_representation_mim.mb3dgdtr_geometric_model_item ../../resources/topology_schema/topology_schema.htm#topology_schema.edge_loop ../../resources/topology_schema/topology_schema.htm#topology_schema.connected_face_set ../shape_property_assignment/sys/5_mim.htm#shape_property_assignment_mim.geometric_model_item


Figure D.2 — MIM entity level EXPRESS-G diagram 1 of 1


© ISO 2018 — All rights reserved