Application module: Assembly component placement requirements ISO/TS 10303-1634:2018-11(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
   4.5 ARM function definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definitions
     5.2.2 MIM entity definitions
     5.2.3 MIM subtype constraint definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Introduction

ISO 10303 is an International Standard for the computer-interpretable representation of product information and for the exchange of product data. The objective is to provide a neutral mechanism capable of describing products throughout their life cycle. This mechanism is suitable not only for neutral file exchange, but also as a basis for implementing and sharing product databases, and as a basis for retention and archiving.

This part of ISO 10303 specifies an application module for the representation of information needed to describe the constraints restricting where components are to be placed in an assembly. These restrictions might be to keep components within a region, or might be restrictions to keep components out of a region.

Components might be grouped and requirements assigned to a group.

Constraints might be applied between specific categories of components.

Items which are considered by the responsible organization to be the basis of the requirement might be identified.

Module attribute data population is restricted to that related to the discrete assembly view.

Clause 1 defines the scope of the application module and summarizes the functionality and data covered. Clause 3 lists the words defined in this part of ISO 10303 and gives pointers to words defined elsewhere. The information requirements of the application are specified in Clause 4 using terminology appropriate to the application. A graphical representation of the information requirements, referred to as the application reference model, is given in Annex C. Resource constructs are interpreted to meet the information requirements. This interpretation produces the module interpreted model (MIM). This interpretation, given in 5.1, shows the correspondence between the information requirements and the MIM. The short listing of the MIM specifies the interface to the resources and is given in 5.2. A graphical representation of the short listing of the MIM is given in Annex D.

In ISO 10303, the same English language words can be used to refer to an object in the real world or concept, and as the name of an EXPRESS data type that represents this object or concept.

The following typographical convention is used to distinguish between these. If a word or phrase occurs in the same typeface as narrative text, the referent is the object or concept. If the word or phrase occurs in a bold typeface or as a hyperlink, the referent is the EXPRESS data type.

The name of an EXPRESS data type can be used to refer to the data type itself, or to an instance of the data type. The distinction between these uses is normally clear from the context. If there is a likelihood of ambiguity, either the phrase "entity data type" or "instance(s) of" is included in the text.

Double quotation marks " " denote quoted text. Single quotation marks ' ' denote particular text string values.



© ISO 2018 — All rights reserved