|
|
Application module:
Assembly physical interface requirement |
ISO/TS 10303-1647:2019(E)
© ISO
|
This clause specifies the EXPRESS schema derived from the mapping
table.
It uses elements from the common resources or from other application
modules and defines the EXPRESS constructs that are specific to this
part of ISO 10303.
This clause constitutes the Module Interpreted Module (MIM) of the
application module.
This clause also
specifies the modifications that apply to the constructs
imported from the common resources.
The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application
modules:
-
use of a supertype entity does not make applicable any of its
specializations, unless the specialization is also imported in the
MIM schema;
-
use of a SELECT type does not make applicable any of its listed types
unless the listed type is also imported in the MIM schema.
Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined
in Annex B.
EXPRESS specification:
*)
SCHEMA Assembly_physical_interface_requirement_mim;
USE FROM
Assembly_functional_interface_requirement_mim;
--
ISO/TS 10303-1635
USE FROM
Layered_3d_shape_mim;
--
ISO/TS 10303-1694
USE FROM
Printed_physical_layout_template_mim;
--
ISO/TS 10303-1737
USE FROM
product_structure_schema
--
ISO 10303-44
(specified_higher_usage_occurrence);
(*
NOTE 1
The schemas referenced above are specified in the following
part of ISO 10303:
| Assembly_functional_interface_requirement_mim |
ISO/TS 10303-1635 |
| Layered_3d_shape_mim |
ISO/TS 10303-1694 |
| Printed_physical_layout_template_mim |
ISO/TS 10303-1737 |
| product_structure_schema |
ISO 10303-44 |
NOTE 2
See Annex D,
Figures
D.1and D.2
for a graphical representation of this schema.
This subclause specifies the MIM types
for this application module. The MIM types and
definitions are specified below.
The apir_requirement_assigned_item type is an extension
of the
requirement_assigned_item type.
It adds the data
types
predefined_requirement_view_definition and shape_aspect
to the list of alternate data types.
NOTE The list of entity data types may be
extended in application modules that use the constructs of
this module.
EXPRESS specification:
*)
TYPE
apir_requirement_assigned_item =
EXTENSIBLE
GENERIC_ENTITY
SELECT
BASED_ON
requirement_assigned_item
WITH
(predefined_requirement_view_definition,
shape_aspect);
END_TYPE;
(*
The apir_document_reference_item type is an extension
of the
document_reference_item type.
It adds the data
type
protocol_physical_layer_definition
to the list of alternate data types.
NOTE The list of entity data types may be
extended in application modules that use the constructs of
this module.
EXPRESS specification:
*)
TYPE
apir_document_reference_item =
EXTENSIBLE
GENERIC_ENTITY
SELECT
BASED_ON
document_reference_item
WITH
(protocol_physical_layer_definition);
END_TYPE;
(*
This subclause specifies the MIM entity for this
module. The MIM entity and definition is specified below.
A protocol_requirement_allocation_to_part_terminal is a type of
requirement_assignment
that implements the ARM concept of
Protocol_requirement_allocation_to_part_terminal.
EXPRESS specification:
*)
ENTITY protocol_requirement_allocation_to_part_terminal
SUBTYPE OF (requirement_assignment);
END_ENTITY;
(*
*)
END_SCHEMA; -- Assembly_physical_interface_requirement_mim
(*
© ISO 2019 — All rights reserved
