Application module: Dimension tolerance ISO/TS 10303-1050:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definitions
     5.2.2 MIM entity definition

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious page
Figure C.3 — ARM entity level EXPRESS-G diagram 2 of 2 ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.limitation_definition_select ./armexpg2.htm ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.angle_data_element ../value_with_unit_extension/sys/4_info_reqs.htm#value_with_unit_extension_arm.length_data_element ../value_with_unit/sys/4_info_reqs.htm#value_with_unit_arm.value_with_unit ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.tolerance_range ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.length_plus_minus_bounds ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.dimension_value_with_limitation ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.angle_plus_minus_bounds ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.plus_minus_bounds ../dimension_tolerance/sys/4_info_reqs.htm#dimension_tolerance_arm.limits_and_fits


Figure C.3 — ARM entity level EXPRESS-G diagram 2 of 2


© ISO 2019 — All rights reserved