Application module: Machining features ISO/TS 10303-1814:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition
     5.2.2 MIM entity definition
     5.2.3 MIM rule definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious pageNext pageLast page
Figure C.10 — ARM entity level EXPRESS-G diagram 9 of 19 ../machining_features/sys/4_info_reqs.htm#machining_features_arm.hole_bottom_condition_select ./armexpg19.htm ./armexpg17.htm ./armexpg18.htm ./armexpg4.htm ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../machining_features/sys/4_info_reqs.htm#machining_features_arm.counterbore_hole ../machining_features/sys/4_info_reqs.htm#machining_features_arm.hole ../machining_features/sys/4_info_reqs.htm#machining_features_arm.spherical_hole_bottom ../machining_features/sys/4_info_reqs.htm#machining_features_arm.blind_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.round_hole ../machining_features/sys/4_info_reqs.htm#machining_features_arm.countersunk_hole ../machining_features/sys/4_info_reqs.htm#machining_features_arm.through_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.flat_with_radius_hole_bottom ../machining_features/sys/4_info_reqs.htm#machining_features_arm.conical_hole_bottom ../machining_features/sys/4_info_reqs.htm#machining_features_arm.flat_with_taper_hole_bottom ../machining_features/sys/4_info_reqs.htm#machining_features_arm.flat_hole_bottom


Figure C.10 — ARM entity level EXPRESS-G diagram 9 of 19


© ISO 2019 — All rights reserved