Application module: Machining features ISO/TS 10303-1814:2019(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
    3.1 Terms and definitions
    3.2 Abbreviated terms

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM type definitions
   4.3 ARM entity definitions
   4.4 ARM subtype constraint definition
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing
     5.2.1 MIM type definition
     5.2.2 MIM entity definition
     5.2.3 MIM rule definitions

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

Mapping tableIndex of EXPRESS-G pagesFirst pagePrevious pageNext pageLast page
Figure C.7 — ARM entity level EXPRESS-G diagram 6 of 19 ../machining_features/sys/4_info_reqs.htm#machining_features_arm.pocket_bottom_condition_select ./armexpg2.htm ./armexpg19.htm ./armexpg2.htm ./armexpg2.htm ./armexpg2.htm ./armexpg2.htm ./armexpg6.htm ./armexpg4.htm ./armexpg6.htm ./armexpg6.htm ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../measure_representation/sys/4_info_reqs.htm#measure_representation_arm.numerical_item_with_unit ../elemental_geometric_shape/sys/4_info_reqs.htm#elemental_geometric_shape_arm.direction ../machining_features/sys/4_info_reqs.htm#machining_features_arm.general_pocket_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.planar_rib_top_floor ../machining_features/sys/4_info_reqs.htm#machining_features_arm.rib_top ../machining_features/sys/4_info_reqs.htm#machining_features_arm.planar_pocket_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.through_pocket_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.pocket_bottom_condition ../machining_features/sys/4_info_reqs.htm#machining_features_arm.rib_top_floor ../machining_features/sys/4_info_reqs.htm#machining_features_arm.general_rib_top_floor


Figure C.7 — ARM entity level EXPRESS-G diagram 6 of 19


© ISO 2019 — All rights reserved