ISO/TS 10303-1641:2019 Assembly module with subassembly


Application module: Assembly module with subassembly	ISO/TS 10303-1641:2019(E) © ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
3.2 Abbreviated terms

4 Information requirements
4.1 Required AM ARM
4.2 ARM entity definitions
5 Module interpreted model
5.1 Mapping specification
5.2 MIM EXPRESS short listing
5.2.1 MIM entity definition

A MIM short names
B Information object registration
C ARM EXPRESS-G
D MIM EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

use of a supertype entity does not make applicable any of its specializations, unless the specialization is also imported in the MIM schema;
use of a SELECT type does not make applicable any of its listed types unless the listed type is also imported in the MIM schema.

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

EXPRESS specification:




         *)

            SCHEMA Assembly_module_with_subassembly_mim;

USE FROM Assembly_module_design_mim; -- ISO/TS 10303-1636 (*

NOTE 1 The schemas referenced above are specified in the following part of ISO 10303:

Assembly_module_design_mim ISO/TS 10303-1636

NOTE 2 See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definition

This subclause specifies the MIM entity for this module. The MIM entity and definition is specified below.

5.2.1.1 assembly_module_component

An assembly_module_component is a type of physical_component that implements the ARM concept of Assembly_module_component.

EXPRESS specification:

*) ENTITY assembly_module_component SUBTYPE OF (physical_component); END_ENTITY; (*




         *)

         END_SCHEMA;  -- Assembly_module_with_subassembly_mim
(*