|
|
Application module:
Assembly module design |
ISO/TS 10303-1636:2018-11(E)
© ISO
|
This clause specifies the EXPRESS schema derived from the mapping
table.
It uses elements from the common resources or from other application
modules and defines the EXPRESS constructs that are specific to this
part of ISO 10303.
This clause constitutes the Module Interpreted Module (MIM) of the
application module.
This clause also
specifies the modifications that apply to the constructs
imported from the common resources.
The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application
modules:
-
use of a supertype entity does not make applicable any of its
specializations, unless the specialization is also imported in the
MIM schema;
-
use of a SELECT type does not make applicable any of its listed types
unless the listed type is also imported in the MIM schema.
Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined
in Annex B.
EXPRESS specification:
*)
SCHEMA Assembly_module_design_mim;
USE FROM
Assembly_module_usage_view_mim;
--
ISO/TS 10303-1642
USE FROM
Assembly_technology_mim;
--
ISO/TS 10303-1649
USE FROM
Physical_component_feature_mim;
--
ISO/TS 10303-1721
USE FROM
Physical_unit_design_view_mim;
--
ISO/TS 10303-1728
USE FROM
Physical_connectivity_layout_topology_requirement_mim;
--
ISO/TS 10303-1826
USE FROM
Physical_connectivity_definition_mim;
--
ISO/TS 10303-1755
(*
NOTE 1
The schemas referenced above are specified in the following
part of ISO 10303:
| Assembly_module_usage_view_mim |
ISO/TS 10303-1642 |
| Assembly_technology_mim |
ISO/TS 10303-1649 |
| Physical_component_feature_mim |
ISO/TS 10303-1721 |
| Physical_unit_design_view_mim |
ISO/TS 10303-1728 |
| Physical_connectivity_layout_topology_requirement_mim |
ISO/TS 10303-1826 |
| Physical_connectivity_definition_mim |
ISO/TS 10303-1755 |
NOTE 2
See Annex D,
Figures
D.1and D.2
for a graphical representation of this schema.
This subclause specifies the MIM entities for this
module. The MIM entities and definitions are specified below.
An assembly_module_design_view is a type of
physical_unit
that implements the ARM concept of
Assembly_module_design_view.
An assembly_module_design_view may be either a
Layered_assembly_panel_design_view
or a
Layered_assembly_module_design_view.
EXPRESS specification:
*)
ENTITY assembly_module_design_view
SUBTYPE OF (physical_unit);
END_ENTITY;
(*
A component_mounting_feature is a type of
physical_component_feature
that implements the ARM concept of
Component_mounting_feature.
EXPRESS specification:
*)
ENTITY component_mounting_feature
SUBTYPE OF (physical_component_feature);
END_ENTITY;
(*
*)
END_SCHEMA; -- Assembly_module_design_mim
(*
© ISO 2018 — All rights reserved
