ISO/TS 10303-1691:2018-11 Interface component


Application module: Interface component	ISO/TS 10303-1691:2018-11(E) © ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
3.2 Abbreviated terms

4 Information requirements
4.1 Required AM ARM
4.2 ARM entity definitions
4.3 ARM subtype constraint definition
5 Module interpreted model
5.1 Mapping specification
5.2 MIM EXPRESS short listing
5.2.1 MIM entity definitions
5.2.2 MIM subtype constraint definition

A MIM short names
B Information object registration
C ARM EXPRESS-G
D MIM EXPRESS-G
E Computer interpretable listings
F Change history
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

use of a supertype entity does not make applicable any of its specializations, unless the specialization is also imported in the MIM schema;
use of a SELECT type does not make applicable any of its listed types unless the listed type is also imported in the MIM schema.

Short names of entities defined in this schema are described in Annex A. Unambiguous identification of this schema is defined in Annex B.

EXPRESS specification:




         *)

            SCHEMA Interface_component_mim;

USE FROM Physical_component_feature_mim; -- ISO/TS 10303-1721 (*

NOTE 1 The schemas referenced above are specified in the following part of ISO 10303:

Physical_component_feature_mim ISO/TS 10303-1721

NOTE 2 See Annex D, Figures D.1and D.2 for a graphical representation of this schema.

5.2.1 MIM entity definitions

This subclause specifies the MIM entities for this module. The MIM entities and definitions are specified below.

5.2.1.1 interface_component

An interface_component is a type of physical_component that implements the ARM concept of Interface_component.

EXPRESS specification:

*) ENTITY interface_component SUBTYPE OF (physical_component); END_ENTITY; (*

5.2.1.2 physical_component_interface_terminal

A physical_component_interface_terminal is a type of physical_component_feature that implements the ARM concepts of:

EXPRESS specification:

*) ENTITY physical_component_interface_terminal SUBTYPE OF (physical_component_feature); END_ENTITY; (*

5.2.2 MIM subtype constraint definition

This subclause specifies the MIM subtype constraint for this module. The subtype constraint places a constraint on the possible super-type / subtype instantiations. The MIM subtype constraint and definition is specified below.

5.2.2.1 physical_component_feature_subtypes

The physical_component_feature_subtypes constraint specifies a constraint that applies to instances of physical_component_feature and enforces the rule that its subtypes physical_component_terminal and physical_component_interface_terminal are exclusive.

EXPRESS specification:

*) SUBTYPE_CONSTRAINT physical_component_feature_subtypes FOR physical_component_feature; ONEOF (physical_component_terminal, physical_component_interface_terminal); END_SUBTYPE_CONSTRAINT; (*




         *)

         END_SCHEMA;  -- Interface_component_mim
(*