Application module: Mechanical design geometric presentation ISO/TS 10303-1313:2008(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

4 Information requirements

This clause specifies the information requirements for the Mechanical design geometric presentation application module. The information requirements are specified as the Application Reference Model (ARM) of this application module.

NOTE 1  A graphical representation of the information requirements is given in Annex C.

NOTE 2  The mapping specification is specified in 5.1. It shows how the information requirements are met by using common resources and constructs defined or imported in the MIM schema of this application module.

The following EXPRESS specification begins the Mechanical_design_geometric_presentation_arm schema and identifies the necessary external references.

EXPRESS specification:

*)
SCHEMA Mechanical_design_geometric_presentation_arm;
(*

4.1 Required AM ARMs

The following EXPRESS interface statements specify the elements imported from the ARMs of other application modules.

EXPRESS specification:

*)
USE FROM Camera_view_3d_arm;    --  ISO/TS 10303-1316

USE FROM Shape_appearance_layers_arm;    --  ISO/TS 10303-1009
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Camera_view_3d_arm ISO/TS 10303-1316
Shape_appearance_layers_arm ISO/TS 10303-1009

NOTE 2   See Annex C, Figures C.1and C.2 for a graphical representation of this schema.

4.2 ARM entity definitions

This subclause specifies the ARM entities for this module. Each ARM application entity is an atomic element that embodies a unique application concept and contains attributes specifying the data elements of the entity. The ARM entities and definitions are specified below.

4.2.1 Mechanical_design_view_area   EXPRESS-GMapping table

A Mechanical_design_view_area is a type of View_area.

EXPRESS specification:

*)
ENTITY Mechanical_design_view_area
  SUBTYPE OF (View_area);
END_ENTITY;
(*

4.2.2 Mechanical_representation_styled_model   EXPRESS-GMapping table

A Mechanical_representation_styled_model is a type of Styled_model.

EXPRESS specification:

*)
ENTITY Mechanical_representation_styled_model
  SUBTYPE OF (Styled_model);
END_ENTITY;
(*



*)
END_SCHEMA;  -- Mechanical_design_geometric_presentation_arm
(*


© ISO 2008 — All rights reserved