Application module: Mechanical design geometric presentation ISO/TS 10303-1313:2008(E)
© ISO

Cover page
Table of contents
Copyright
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations

4 Information requirements
   4.1 Required AM ARMs
   4.2 ARM entity definitions
5 Module interpreted model
   5.1 Mapping specification
   5.2 MIM EXPRESS short listing

A MIM short names
B Information object registration
C ARM EXPRESS-G   EXPRESS-G
D MIM EXPRESS-G   EXPRESS-G
E Computer interpretable listings
Bibliography
Index

5.2 MIM EXPRESS short listing

This clause specifies the EXPRESS schema derived from the mapping table. It uses elements from the common resources or from other application modules and defines the EXPRESS constructs that are specific to this part of ISO 10303.

This clause constitutes the Module Interpreted Module (MIM) of the application module.

This clause also specifies the modifications that apply to the constructs imported from the common resources.

The following restrictions apply to the use, in this schema, of constructs defined in common resources or in application modules:

EXPRESS specification:

*)
SCHEMA Mechanical_design_geometric_presentation_mim;

USE FROM Camera_view_3d_mim;    --  ISO/TS 10303-1316

USE FROM Shape_appearance_layers_mim;    --  ISO/TS 10303-1009

USE FROM aic_mechanical_design_geometric_presentation;    --  ISO 10303-517

USE FROM presentation_organization_schema    --  ISO 10303-46
  (light_source,
   light_source_ambient,
   light_source_directional,
   light_source_positional,
   light_source_spot);
(*

NOTE 1   The schemas referenced above are specified in the following part of ISO 10303:

Camera_view_3d_mim ISO/TS 10303-1316
Shape_appearance_layers_mim ISO/TS 10303-1009
aic_mechanical_design_geometric_presentation ISO 10303-517
presentation_organization_schema ISO 10303-46

NOTE 2   See Annex D, Figure D.1 for a graphical representation of this schema.



*)
END_SCHEMA;  -- Mechanical_design_geometric_presentation_mim
(*


© ISO 2008 — All rights reserved